An integrated design office.
No catalogue: we design the most effective solution for your part — tested, validated, sometimes patented.
From analysis to prototype through to production.
Five steps, from part to production.
Part analysis
Geometry, weight, fragilities, sensitive points, finish. We always start from the product, never from a standard.
Transport & handling constraints
Type of transport, distance, stacking, palletisation, workshop handling. The solution must hold up from the dock to the unpacking station.
Material selection
Cardboard, PE foam, bubble film, plastic film: we combine our trades for the right balance of protection / cost / output.
Prototype & Validation
A first real, hands-on version. Drop, vibration and handling tests — validated with your actual part, not on paper.
Industrialisation & Production
Once the solution is finalised, production is launched in our workshops, at rates suited to your volumes.
Our work in 3D.
Every packaging is modelled before production. Here are a few projects from our design office.
Designed right, for the job and for the planet.
Eco-design means meeting the exact need while optimising dimensions, material quantity, material choice and recyclability — cutting environmental impact without giving up any protection.
It's also the best answer to the EU's PPWR regulation, which calls for leaner, recyclable packaging.
Less material, same protection
We size every pack as close to the part as possible: needless board and void disappear while the hold stays intact.
PPWR-ready
EU rules are pushing towards reduced, recyclable packaging. Our designs anticipate those requirements from the drawing board.
Recyclability built in
Material choice, single-material design, easy sorting: the pack's end of life is considered from the very first sketch.